Print Page | Close Window

D-10, D-12 Light parts needed

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=156894
Printed Date: 24 Oct 2025 at 9:43pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: D-10, D-12 Light parts needed
Posted By: Ted in NE-OH
Subject: D-10, D-12 Light parts needed
Date Posted: 02 Jan 2019 at 6:04pm

I need the following parts for a late model D10, D12

Cast bracket that mounts to the RIGHT fender under the forward facing light.

Cast bracket that mounts to the right fender under the REAR facing light

Light, forward facing fender light.

Note: these parts may be common to D14, D14

Please respond via e-mail with price and condition of part

actcseifert@hotmail.com



-------------
CA, WD, C, 3 Bs, 2 Gs, WC, I-400, 914



Replies:
Posted By: tbird
Date Posted: 02 Jan 2019 at 6:12pm
djs tractor parts have them  fits d 10 through d19  at 45.00 each phone no 734 320 3470


Posted By: DSeries4
Date Posted: 02 Jan 2019 at 8:16pm
D14 Does not use them - headlights are on the grille shell.  However, D15 Series II, D17 Series III and IV and the D19 use the same headlights and mountings.  They are hard to find used though.  As mentioned above your best bet is to get new repros from DJs or one of the other vendors here.



-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080


Posted By: PaulB
Date Posted: 03 Jan 2019 at 1:18am
I have those light bases avalable, $20 each plus the shipping.
I’ll have to wait until I get home to add the picture

-------------
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY


Posted By: Dave H
Date Posted: 03 Jan 2019 at 3:58am
Way back when i was in the same boat.  Got a casting from DJS.

As I foggily recall it was right dimentionally but yes a ROUGH casting that required some working down.

So depending on the price, i would go for the used if the price was right comparatively.  Just a thought.


Posted By: PaulB
Date Posted: 03 Jan 2019 at 11:30am
Here is a picture of the light bases I have available. The castings I get are very good quality, I have them casted by the Amish, not from China. Unfortunately the picture is a bit fuzzy



-------------
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net