Farm Equipment - switching engines on Allis 440

Print Page | Close Window

switching engines on Allis 440

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=15674
Printed Date: 04 Feb 2025 at 4:39pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: switching engines on Allis 440

Posted By: jim
Subject: switching engines on Allis 440
Date Posted: 25 Jul 2010 at 12:51pm

Switching engines on my 440 Allis. The old engine had a broken crank. Anyone on this forum worked on a 440? By that I mean the factory service manual instructs you to remove the transmission with the engine. Then unbolt engine from the transmission. It seems like you should be able to pull the engine and leave the transmission in place. It looks like the biggest challenge would be to support the transmission so you could seperate the two while in the tractor. Anyone with firsthand experience.

Jim

Replies:

Posted By: injpumpEd
Date Posted: 25 Jul 2010 at 9:31pm

the engine is basically the only thing holding trans in. you can pull trans out the bottom, then pull engine by itself. those steigers aren't the easiest to work on for sure. I preferred the versatiles when it comes to big four wheel drive tractors.

-------------
210 "too hot to farm" puller, part of the "insane pumpkin posse". Owner of Guenther Heritage Diesel, specializing in fuel injection systems on heritage era tractors. stock rebuilds to all out pullers!