#7 rake parts needed
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=155953
Printed Date: 01 Aug 2025 at 10:00am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: #7 rake parts needed
Posted By: acjwb
Subject: #7 rake parts needed
Date Posted: 27 Nov 2018 at 7:33pm
| I am needing the pto shaft for a #7 hay rake. I have the back part that attaches to the rake gearbox. Thanks for any help. |
Replies:
Posted By: PaulB
Date Posted: 28 Nov 2018 at 4:17am
|
I have some of those parts available, NOS. I’ll take a look to see which PTO parts I have later after I get home. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
Posted By: B26240
Date Posted: 28 Nov 2018 at 6:16am
| I have the gearbox but no pto shafts. |
Posted By: PaulB
Date Posted: 28 Nov 2018 at 4:54pm
|
I have the front section of the rear driveshaft. Part # 525569. This is the hollow square tube that has the area for the carrier bearing and then the yoke goes on in front of that. I have a picture although it doesn't want to show up. I sent you and Email. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
Posted By: thomas winchester
Date Posted: 05 May 2020 at 3:34pm
|
is it for sale |
Posted By: PaulB
Date Posted: 05 May 2020 at 8:21pm
All of my NOS and used rake parts Went wit my rake when I sold it. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
thomas winchester wrote:Posted By: BSG
Date Posted: 30 Jul 2025 at 7:01pm
| Im in need of a spocket for the main drive of a NO 7 rake.. Part number 517828. a 36tooth #60 chain with 1 1/8" hub. |
Posted By: DanielW
Date Posted: 31 Jul 2025 at 6:47am
|
One of mine needed a new sprocket - I just went to the local Napa (which also serves as an industrial supply) and had them order one for me. Any industrial supply worth their salt will place regular orders to suppliers like Martin or Browning, who would have one in-stock. If this were a couple of weeks ago I might have had one to ship to you. But I just sold the three of those rakes I have with all the spare parts I had kicking around. Video link here explains tooth and bearing sourcing in case you ever need any of them. http://www.youtube.com/watch?v=gl73hX0Ma74" rel="nofollow - http://www.youtube.com/watch?v=gl73hX0Ma74
 |