Farm Equipment - 7000 transmission brake-pedal travel question

Print Page | Close Window

7000 transmission brake-pedal travel question

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=15510
Printed Date: 04 Feb 2025 at 10:47am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 7000 transmission brake-pedal travel question

Posted By: Hurst
Subject: 7000 transmission brake-pedal travel question
Date Posted: 21 Jul 2010 at 11:16am

How far down should the inching pedal go down before the brake engages? I adjusted mine per the bulletin TBran sent me and the brake engages when the pedal is about half way down. I check this by turning the PD housing by hand while the guy I work with pushed down the pedal slowly. I feel like I did something wrongly. I double checked all my measurements and they looked good according to the Allis service bulletin (4.6 inch spring length and .25 inch gap between the spacer and the front adjusting nut all with the pedal down against the pedal stop).

Hurst

-------------
1979 Allis Chalmers 7000
5800 Hours

Replies:

Posted By: DrAllis
Date Posted: 21 Jul 2010 at 12:52pm

If the clutch pedal is all the way down to the stop bolt(very important...to the stop bolt) there should be the .25" (1/4") gap between the spacer like you said. That's all you need to worry about.

Posted By: Hurst
Date Posted: 21 Jul 2010 at 3:55pm

I'll have to double check on that again. It may have been stopping on something else, like the rubber boot or floor pad.

Hurst

-------------
1979 Allis Chalmers 7000
5800 Hours