6060 ?
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=15450
Printed Date: 04 Feb 2025 at 12:42pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 6060 ?
Posted By: Jim in SE ND
Subject: 6060 ?
Date Posted: 19 Jul 2010 at 9:14pm
|
Did the 6060 require the same update on the front of the crankshaft to help prevent the bearing failure that the 6080 had? thanks
|
Replies:
Posted By: AllisFreak MN
Date Posted: 19 Jul 2010 at 9:28pm
Yes.
-------------
'49 A-C WD, '51 A-C WD, '63 A-C D17 Series III, 1968 A-C One-Seventy, '82 A-C 6060, '75 A-C 7040, A-C #3 sickle mower, 2 A-C 701 wagons, '78 Gleaner M2
|
Posted By: ScooterBuck
Date Posted: 20 Jul 2010 at 9:21pm
|
Does anyone have a picture of that update that they could post on this thread?
|
Posted By: AllisFreak MN
Date Posted: 20 Jul 2010 at 9:47pm
Can't post pics but can tell you that it is a bracket bolted in front of the crank pulley. Appears to be bolted to the engine block in three places. The bracket has a grease fitting in the lower front. It holds the crank in position so when the PTO clutch is disengaged it does not put too much foreward pressure on the crankshaft, taking out the crank bearings. Apparently the 433T & 433I engines were not designed to be in a tractor with a clutch putting foreward pressure on the crank shaft as they did not have thrust bearings. They were meant to be in belt drive applications such as combines and dozers.
-------------
'49 A-C WD, '51 A-C WD, '63 A-C D17 Series III, 1968 A-C One-Seventy, '82 A-C 6060, '75 A-C 7040, A-C #3 sickle mower, 2 A-C 701 wagons, '78 Gleaner M2
|
|