433T
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=148111
Printed Date: 16 Oct 2025 at 6:03am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 433T
Posted By: 740Miller
Subject: 433T
Date Posted: 02 Mar 2018 at 8:13pm
|
Working on overhauling this motor. When pulling this down I noticed the two gears on the oil pump ride on a gear on the crank. Question? Is it normal for the teeth on the right gear not to engage the main drive gear? Confused? Me too. If I knew how to add a picture I would. Anyone's help would be appreciated. Thanks |
Replies:
Posted By: DrAllis
Date Posted: 02 Mar 2018 at 8:50pm
| Crankshaft gear engages only ONE balancer gear. THEY HAVE TO BE TIMED !!!!!!! |
Posted By: 740Miller
Date Posted: 02 Mar 2018 at 9:04pm
|
That's what I'm looking at a balancer? Is there a timing mark on these or do I need to mark them before I pull it apart? Thanks this is my first 433 |
Posted By: LB0442
Date Posted: 02 Mar 2018 at 9:42pm
If you didn't disassemble the balancer you should just need the 2nd page.  |
Posted By: 740Miller
Date Posted: 03 Mar 2018 at 6:03am
| Thanks this helped a lot, so it says to change the bearings. Any ideas where to get the correct ones? |
Posted By: DrAllis
Date Posted: 03 Mar 2018 at 6:36am
| Four- 74009919 needle bearings and possibly four- 4008917 thrust washers from an AGCO dealership. |
Posted By: DrAllis
Date Posted: 03 Mar 2018 at 6:37am
| Ooops....74008917 thrust. |
Posted By: 740Miller
Date Posted: 03 Mar 2018 at 8:04pm
|
Thanks Dr. Allis, I appreciate the help |