Rear drive seal
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=14747
Printed Date: 03 Feb 2025 at 7:58am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Rear drive seal
Posted By: WC7610
Subject: Rear drive seal
Date Posted: 05 Jul 2010 at 9:53am
|
Still working on the RC rearend.
Replacing the seal between the differential and the brakes. Old seal had a tin "carrier" that held the seal. The new seal has a solid steel "carrier" that is slightly larger than the hole it needs to go into. Old part number 70207708 was changed to 72511216 "Oil seal assembly".
My question is what suggestions now? I'm tempted to straighten out the old tin "carrier" and reuse it with the new seal-not sure what else to do.
 ------------- Thanks Most Bad Government has grown out of Too Much Government- Thomas Jefferson |
Replies:
Posted By: WC7610
Date Posted: 05 Jul 2010 at 10:17am
|
Just check the old seal versus the new. The OD is larger for the new seal as well. The inside diameter looks ok. Agco parts made in Tiawan. ------------- Thanks Most Bad Government has grown out of Too Much Government- Thomas Jefferson |
Posted By: Gary in da UP
Date Posted: 05 Jul 2010 at 11:56am
I just replaced mine and got seals from napa skf 19229 they fit the stamped seal retainer very well, the seal between the drum and pinon bearing is skf 19407 and will require some machineing to fit the retainer. I had about .007 removed to make it fit. Gary
|