Farm Equipment - D17 Series 1 PTO Lever

Print Page | Close Window

D17 Series 1 PTO Lever

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=14544
Printed Date: 16 Nov 2024 at 12:28pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D17 Series 1 PTO Lever

Posted By: willard
Subject: D17 Series 1 PTO Lever
Date Posted: 30 Jun 2010 at 10:32am

My D17 PTO lever does not "catch" or turn on and off the PTO anymore. I seem to remember that there may be a roll pin inside that needs to be replaced to fix this problem. Can anyone give me some insite? Thank you for any help.

Replies:

Posted By: DSeries4
Date Posted: 30 Jun 2010 at 10:37pm

Yes, it is quite possible that the roll pin needs replacing. Can be accessed by the panel on the right side of the torque tube by the power director. However, I would find it hard to work through that small hole, it would be best to split the tractor maybe.

Posted By: willard
Date Posted: 01 Jul 2010 at 8:44am

Thank you for the reply. I will rty through the right side panel. Hope my fat fingers can fit in the space.

Posted By: JC-WI
Date Posted: 01 Jul 2010 at 9:13am

Willard, your roll pin is sheared. Going to be a problem just to get it out. And you won't be able to get a new pin in, or at least I couldn't get it in when I had to do it. So I grabbed a shearpin (bolt and lock nut) for the 273 New Holland baler and tightened that in there and never has caused a problem since.