190 xt transmission problem
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=143715
Printed Date: 24 Sep 2025 at 3:50am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 190 xt transmission problem
Posted By: Coalminer618
Subject: 190 xt transmission problem
Date Posted: 22 Oct 2017 at 7:15pm
|
I was discing with my190xt. It locked up in transmission or rear end. You put trans in neutral pd in low it will move. Put in any gear an pd in low will kill motor. Any ideas
|
Replies:
Posted By: Dakota Dave
Date Posted: 22 Oct 2017 at 8:00pm
|
You have a broken shifter fork it's stuck in one gear. And the forks won't disengage that gear when I gagging another. A trany in two gears won't move at all. When you put it back in neutral your in whatever gear has the broken shift fork. THIS IS JUST A EDUCATED GUESS based on the information you have given. Remove the floor plate and shift tower to verify. Fortunately a shifter fork can be replace without splitting it. Don't drive it anywhere a broken shifter fork going between the gears will really destroy more parts.
|
Posted By: MACK
Date Posted: 22 Oct 2017 at 10:06pm
|
Check transmission oil, sounds like it is low on oil and has welded low gear bushing to pinion shaft. Put it in first gear and see if it will move. MACK
|
Posted By: Coalminer618
Date Posted: 23 Oct 2017 at 7:11pm
|
It moves when in first gear. No shifting forks broke. Could it be pd trying to go in high an low at same time?
|
Posted By: Dakota Dave
Date Posted: 23 Oct 2017 at 8:21pm
|
You said put transmition in neutral and PD in low it moves. If this is correct it's still in gear.
|
Posted By: MACK
Date Posted: 23 Oct 2017 at 9:02pm
|
Just what I said to start with. It moves in first gear, because first gear is welded to pinion shaft. Good luck in pressing it out. MACK
|
|