Farm Equipment - D17 Series iv brakes

Print Page | Close Window

D17 Series iv brakes

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=142570
Printed Date: 12 Nov 2024 at 10:38am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D17 Series iv brakes

Posted By: Terry McStotts
Subject: D17 Series iv brakes
Date Posted: 17 Sep 2017 at 8:51pm

I am new to this group, I was adjusting the brakes, the rod was rusted and twisted off. Does anyone know if you can get a new pivot pin block or do you need to get one machined or possibly get the broken rod out and weld and thread the rod? Thanks

Replies:

Posted By: MACK
Date Posted: 17 Sep 2017 at 9:02pm

After you get block out, some heat will usually loosen the broken rod. MACK

Posted By: Terry McStotts
Date Posted: 17 Sep 2017 at 9:14pm

Thanks, then cut the rod and thread it and use rod coupling outside of housing with threaded rod back to pivot pin

Posted By: DrAllis
Date Posted: 18 Sep 2017 at 9:12am

On a 180 and 185, the left brake rod has a threaded clevis/yoke on the brake pedal end. It is 3/8" NF threads. If I have a brake rod that I think is going to twist off, I cut off the front end and thread it for the clevis to avoid pulling the rear axle out to repair a broken off rod.

Posted By: Terry McStotts
Date Posted: 18 Sep 2017 at 2:48pm

I like that idea, I going to do that! I got the pivot pin out this morning and got the rod out of it.

Posted By: DougG
Date Posted: 18 Sep 2017 at 6:08pm

That Dr Allis has all kinds of good trickes up his sleeve !