Print Page | Close Window

Coolant in 190XT oil pan

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=140356
Printed Date: 22 Aug 2025 at 7:06am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: Coolant in 190XT oil pan
Posted By: MaxinSC
Subject: Coolant in 190XT oil pan
Date Posted: 12 Jul 2017 at 8:21pm
A couple of weeks ago. i was baling hay with my 190XT.  When I was finished baling, as I walked by, the right side of the engine was covered in engine oil. Oil level was ok, so I carried it to the house.  When I was checking the tractor, I found the fan belt loose.  My next step was to change the rocker arm cover gasket.  There was a little gob of vaseline looking junk around the vent tube, but no other signs of anything but engine oil.  Once back together, I found the radiator about 1-1/4 gallons low.  I have to add a little water occassionally but usually less than 1/2 gallon.  I went out tonight to get ready to bush hog the pastures. When I checked the oil level  it was slightly above the full standing mark.  It was about level after the gasket change.  I had a funny feeling, so I dropped the oil plug and about 2 seconds of antifreeze came out before the oil.  I HAD a band temp sending unit, but I feel the tractor did not run hot.  There was no steam around the radiator and it felt normal temps while I was checking out the oil leak in the field. Does anyone have any feel as to what I am facing?  Thanks for any advice or suggestions in advance.



Replies:
Posted By: 210Postin
Date Posted: 12 Jul 2017 at 8:37pm
Would guess sleeve o rings pull pan pressure tester on cooling system to verify.


Posted By: Brad in WA
Date Posted: 12 Jul 2017 at 8:41pm
Sleeve orings and/or cylinders have pin holes. Complete engine overhaul. May have to sleeve lower bores. Been there, done that. I would stop running it immediately or you might be buying a crank.


Posted By: SteveM C/IL
Date Posted: 13 Jul 2017 at 12:06pm
drop pan fill radiator pressure 5-7 pound and look for antifreeze. sounds like it will show quickly



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net