7000
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=139697
Printed Date: 12 May 2025 at 4:31pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 7000
Posted By: LaJaMe
Subject: 7000
Date Posted: 22 Jun 2017 at 10:13pm
|
Have an ac 7000. Everything fine accept when you put it in reverse, there is noise i think in the rear end.. Any thoughts on what we maybe looking at. Thanks
|
Replies:
Posted By: MACK
Date Posted: 22 Jun 2017 at 10:23pm
|
Tooth bad on one of three reverse gears. Reverse directly behind park causes a problem with reverse gears. Operator pushes clutch down, pulls shifter from park to reverse, transmission has not stopped yet and gears clash, causing damage to reverse gears. MACK
|
Posted By: LaJaMe
Date Posted: 23 Jun 2017 at 8:20am
Posted By: WF owner
Date Posted: 23 Jun 2017 at 6:45pm
|
I believe you can repair it without splitting it.
|
Posted By: MACK
Date Posted: 23 Jun 2017 at 10:06pm
|
The only gear that can be replaced without a split is the sliding gear. MACK
|
Posted By: Hurst
Date Posted: 23 Jun 2017 at 10:42pm
If it's the sliding gear, which was made out of softer metal, I believe, than the other two gears, you need to pull both the shifter top and the rear end cover, as the shaft has a retainer that is bolted on the differential side. The new gear will need to be honed to the size of the shaft, so you will need to take them to a machine shop, all assuming that is your problem. The gear is available aftermarket. The other gears are on your transmission shafts. I know the countershaft gear is actually machined into the shaft itself. I can't remember about the top gear.
Hurst
-------------
1979 Allis Chalmers 7000
5800 Hours
|
|