Farm Equipment - Wd clutch pedal return

Print Page | Close Window

Wd clutch pedal return

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=137635
Printed Date: 20 Sep 2025 at 4:33pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Wd clutch pedal return

Posted By: Brampton 02 gt
Subject: Wd clutch pedal return
Date Posted: 21 Apr 2017 at 8:28pm

I put a new clutch/brake pedal shaft. The pedals were also machined. The clutch pedal doesn't snap back nicely like it should. Should I have greased it better. I used the zirk but it might not cover the whole shaft. I wonder if the tolerance is too tight or could the spring be week on the throw bearing. Is the spring easy to change?

Replies:

Posted By: Stan IL&TN
Date Posted: 22 Apr 2017 at 10:34am

Everything you mentioned could cause the issue. I would remove clean and grease everything and if it still sticks then try a new spring. You should be able to replace the spring through the bottom access window.

-------------
1957 WD45 dad's first AC

1968 one-seventy

1956 F40 Ferguson

Posted By: Brampton 02 gt
Date Posted: 22 Apr 2017 at 5:22pm

Found the problem. Too many shims on the brake side of shaft was binding ped into housing.
Thanks