Farm Equipment

Print Page | Close Window

2 ?

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=13708
Printed Date: 01 Feb 2025 at 10:55pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 2 ?

Posted By: kinghunter
Subject: 2 ?
Date Posted: 11 Jun 2010 at 5:02am

I have two questions if you couldnt tell. first one is what do i run for oil in the rear of a allis 190 is it 80/90 weight gear oil or do i run hydraulic oil in the rearend.

The second question is i just aquired a white top little round baler that had been restored and im going to try it out here soon does anyone have any pointers to help me get started like do i run a my wd45 full throttle or do i run it half any help on what i need to get started.

Replies:

Posted By: Joe(OH)
Date Posted: 11 Jun 2010 at 10:27am

The 190 should have trans/hydraulic in the rear end and 80/90 in the bull gears. As far as the Roto Baler, fist make sure that your brake is free. I have found when bailing that they seem to work best at full speed. If you need any help or have any questions, send me a message.
Good luck,
Joe

-------------
Life is simpler when you plow around the stump.

Posted By: JayIN
Date Posted: 11 Jun 2010 at 10:39am

rake the windrow as wide as you can. Not tall, but wide. Like you would throw 2 windrows just together-- beside each other---just touching. This makes for a more uniform bale and loads it evenly. My Dad bought one new in 1947 and used it until 1995. As you can tell, my job was raking!

-------------
sometimes I walk out to my shop and look around and think "Who's the idiot that owns this place?"