tilt steering mechanism on 190xt
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=136104
Printed Date: 22 Aug 2025 at 6:21am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: tilt steering mechanism on 190xt
Posted By: troy(el paso, il)
Subject: tilt steering mechanism on 190xt
Date Posted: 12 Mar 2017 at 8:19am
|
Hi All- Does anyone have an exploded view or parts diagram of the tilt steering mechanism on a 190xt? Going to attempt to fix mine, but haven't been underneath the steering column yet to take a look at the mechanism. Just trying to figure out what I'm getting into..... Thanks in advance, Troy |
Replies:
Posted By: MACK
Date Posted: 12 Mar 2017 at 9:19am
| What are you doing under there? MACK |
Posted By: DSeries4
Date Posted: 12 Mar 2017 at 9:37am
|
It doesn't tilt, right? Most likely, the shaft that the steering column pivots on is seized up - mine was. See the picture below. Loosen the nut at the bottom, this will relax the clamp that holds it in place. Try moving the column up and down. IF it doesn't move, it is seized. Use lots of oil to get it moving freely. After that, snug the nut up again and try moving the linkage. http://s526.photobucket.com/user/szalmyr/media/190XT/DSC04041_zpsokzp4xip.jpg.html" rel="nofollow">  ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: troy(el paso, il)
Date Posted: 12 Mar 2017 at 4:08pm
|
Myron, I will try that. My steering column just slides up and down in the slot without locking. Does the mechanism allow to lock the steering column in different positions? Thanks.... |
Posted By: DSeries4
Date Posted: 12 Mar 2017 at 9:26pm
|
Ok, you have the opposite problem that I had. Try tightening the castle nut. When pulling out on the knob, you should be able to move the column and should lock when you release it.
------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: MACK
Date Posted: 12 Mar 2017 at 10:12pm
| There is two little round brake pads in there. Could have broken and fell out. MACK |
Posted By: troy(el paso, il)
Date Posted: 13 Mar 2017 at 5:51am
|
Ok,.........thanks Mack and Myron for the help.... Troy |