Farm Equipment - combine engine

Print Page | Close Window

combine engine

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=13310
Printed Date: 01 Feb 2025 at 12:06pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: combine engine

Posted By: Cb NwO
Subject: combine engine
Date Posted: 02 Jun 2010 at 8:58pm

I'm stickin an e gleaner combine engine in a tractor and can't get it to react to the throttle like it should, I even put the governor off of the tractor in it but still it's either idle or pretty much everything she's got. Any suggestions?

Replies:

Posted By: niel ev
Date Posted: 03 Jun 2010 at 9:59am

Did you change the govenor housing also are did you leave the combines on it ? The tractors gov. spring has a wieght in it and the combines doesn't ,just wondering Niel

Posted By: Cb NwO
Date Posted: 03 Jun 2010 at 12:08pm

changed everything, including the spring. Put a timing cover from a tractor on it so there isn't really much else to change so I'm kind of baffled.

Posted By: skipwelte
Date Posted: 03 Jun 2010 at 12:13pm

Take the rod going to the carb throttle off and at front of the engine. Move the throttle lever to wide open, grap the rod you just unhooked and pull it toward the front of the engine, is shoud just be able to go back into the hole in the arm, can be just a shade short. If it wont hook up, the bend the arm until the rod just slides in the hole. HTH