Snap coupler eye dimensions
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=132867
Printed Date: 22 Nov 2024 at 2:02am Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Snap coupler eye dimensions
Posted By: littlemarv
Subject: Snap coupler eye dimensions
Date Posted: 20 Dec 2016 at 8:13pm
Anybody got a snap coupler implement handy? Mine are all 20 miles away. If I remember right, they are just loops made out of round stock. I think all I need is the diameter of the round stock, and length and width of the hole that the hook latches into.
Thanks in advance.
------------- The mechanic always wins.
B91131, WC23065, WD89101, CA29479, B1, Early B10, HB212, 416H
|
Replies:
Posted By: jaybmiller
Date Posted: 20 Dec 2016 at 8:34pm
I make mine out of 3/4" round bars, that I KNOW, now the 'eye', I made a 'U', inside dimension is 1 1/2", about 4 or 5" long. If you want me to, I'll take real dimension tomorrow come daylight.... Jay
------------- 3 D-14s,A-C forklift, B-112 Kubota BX23S lil' TOOT( The Other Orange Tractor)
Never burn your bridges, unless you can walk on water
|
Posted By: littlemarv
Date Posted: 20 Dec 2016 at 8:48pm
That sounds about right. If you have a minute, throw a tape measure on one and let me know. Thanks.
------------- The mechanic always wins.
B91131, WC23065, WD89101, CA29479, B1, Early B10, HB212, 416H
|
Posted By: bthompson
Date Posted: 07 Nov 2024 at 5:46pm
Does anybody know where I can get a snap coupler eye?
|
Posted By: IBWD MIke
Date Posted: 08 Nov 2024 at 8:48am
Post an add in the classified's is your best bet.
|
Posted By: bthompson
Date Posted: 08 Nov 2024 at 9:10am
Posted By: Fred in Pa
Date Posted: 09 Nov 2024 at 10:58am
[QUOTE=bthompson] Does anybody know where I can get a snap coupler eye?
------------- He who dies with the most toys is, nonetheless ,still dead. If all else fails ,Read all that is PRINTED.
|
Posted By: Mikez
Date Posted: 11 Nov 2024 at 7:41am
What are you putting the eye on.
|
Posted By: bthompson
Date Posted: 11 Nov 2024 at 8:20am
I found an eye. Thanks for getting back with me. Someone cut the eye off of A two bottom plow. Now I need to get the tongue length correct.
|
|