CA Cultivator Depth Stop
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=13141
Printed Date: 01 Feb 2025 at 10:59am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: CA Cultivator Depth Stop
Posted By: Jim-Ohio
Subject: CA Cultivator Depth Stop
Date Posted: 30 May 2010 at 7:03am
| I recently purchased a set of cultivators for my CA. From looking through the operators manual I see that I am missing the depth stop mechanism for the rear bar. It attaches to the R.H. hydraulic cylinder pin on one end and to the rock shaft on the other end. The one end looks like a big washer on the end of a rod with a movable collar that goes on the hyd pin & the other end is a tube with a pin in the end to attach to the rock shaft. Does anyone have one of these around that doesn't need it anymore? Part #'s : 321444, 320607, 319997, 916587 |
Replies:
Posted By: alan-nj
Date Posted: 30 May 2010 at 10:02am
| i don't have an extra one, but i found i didn't need one as the rear cultivator on my ca doesn't want to go in very deep. i actually put weights on my rear tool bar to help get more depth. alan |
Posted By: Jim-Ohio
Date Posted: 02 Jun 2010 at 12:02pm
|
http://www.allischalmers.com/new/forum/uploads/790/tractor_2_20100602094210.pdf - uploads/790/tractor_2_20100602094210.pdf If no one has one of these to sell would someone have one that they could make some measurements off of so that I could make one? Doesn't look too complicated. Thanks
|
Posted By: NC Bruce
Date Posted: 02 Jun 2010 at 12:22pm
|
You might try some of the spring-type, c-shaped, clips that are used on pull-type Bush Hog hydraulic cylinders. These clips would not scar your cylinder rod.
Many farmers use these to control how low the pull-type Bush Hog can mow, when you let the hydraulic lift float or all the way down.
|
Posted By: mnoonan-NEWI
Date Posted: 02 Jun 2010 at 1:36pm
|
Jim, attached is a picture of the parts you need. Mine are not for sale, but I will give you the dimensions.
Link-Depth Stop: 3/4" dia. x 14 1/2" overall out to out length. Hoop o.d. is 2-7/16", i.d. is 1-1/16". Tube-Depth Stop: 13/16" i.d. x 1-1/16" o.d. x 12-1/2" long with a 11/16" dia. hole w/ center of hole 3/4" from end. The set collar is a casting w/ a 1/2" dia. x 3/4" sq. head bolt. Let me know if you need any other info and good luck. Mike |
Posted By: mnoonan-NEWI
Date Posted: 02 Jun 2010 at 1:45pm
Here is the picture. |
Posted By: Fred in Pa
Date Posted: 02 Jun 2010 at 3:56pm
|
Posted By: Jim-Ohio
Date Posted: 03 Jun 2010 at 7:56am
| Thanks for the pictures. Jim |