Farm Equipment - 200 injection pump

Print Page | Close Window

200 injection pump

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=131184
Printed Date: 21 May 2025 at 10:30pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 200 injection pump

Posted By: alc609
Subject: 200 injection pump
Date Posted: 10 Nov 2016 at 11:59pm

When pulling injector pump, do you line up two small timing lines behind the inspection plate on side of pump? Or is there anything else to line up? There is cap nut out in front of pump on the block, is there anything to look for there? Thanks

Replies:

Posted By: Charlie175
Date Posted: 11 Nov 2016 at 5:27am

Set the timing per manual for #1 cylinder which should line up the marks on your pump.

I then just removed mine. Take note when you pull it off, the "Dot" on the pump side slot and on the drive shaft as they line up also.

-------------
Charlie

'48 B, '51 CA, '56 WD45 '61 D17, '63 D12, '65 D10 , '68 One-Ninety XTD