Farm Equipment - I600 Rear Axle???

Print Page | Close Window

I600 Rear Axle???

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=131078
Printed Date: 22 May 2025 at 5:23am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: I600 Rear Axle???

Posted By: Rib Lake Allis
Subject: I600 Rear Axle???
Date Posted: 08 Nov 2016 at 8:53pm

I'm replacing the brakes on my I600 and there is a bushing on the axle shaft near the brake drum. That bushing is worn about 3/16"-1/4" on the top side. What could cause this? The bearings apear to be good. Any help is appreciated Thanks Steve.

Replies:

Posted By: Eric B
Date Posted: 09 Nov 2016 at 4:17pm

Maybe post a picture and that might help...unless someone in the past has put some kind of speedy sleeve for the seal there isn't supposed to be a bushing there on the shaft. You say worn on the top?? When the shaft turns any wear should be the same all around?

-------------
Currently- WD,WC,3WF's,2 D14's B. Previously- I 600,TL745,200,FL9,FR12,H3,816 LBH. Earth has no sorrow that Heaven cannot heal!

Posted By: DiyDave
Date Posted: 09 Nov 2016 at 6:26pm

Could've been something someone added, through the years, or it had bad bearings, once that were replaced, before you got it. I'd get a look at the exploded parts diagram, to see if its an added part...

Posted By: Rib Lake Allis
Date Posted: 09 Nov 2016 at 7:18pm

After looking at it again today I see that it isn't a bushing. But it still puzzles me why that hole is oblonged.