WD45 governor thrust bearing
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=125848
Printed Date: 31 Aug 2025 at 3:57am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: WD45 governor thrust bearing
Posted By: Ken McGregor
Subject: WD45 governor thrust bearing
Date Posted: 13 Jul 2016 at 3:50pm
I am looking for the measurements of the governor thrust bearing on a WD45. I need inside, outside diameters and the width of the bearing. Apparently this bearing is not available at any of the standard bearing locations but with the proper measurements, I may be able to locate from a different supplier.
I will keep the Forum informed if I find a source of new ones. I have located a few good used ones on their holders but am still searching for a new one.
Thanks in advance for this
regards,
Ken McGregor
|
Replies:
Posted By: DrAllis
Date Posted: 13 Jul 2016 at 4:52pm
|
You know, I've been working on those engine for 40 years and have never replaced one of them yet.
|
Posted By: mgburchard
Date Posted: 13 Jul 2016 at 5:10pm
|
Changed one out about 3 year ago . Carried bearing down to motion industries and walked out with one a few minutes latter
|
Posted By: Ken McGregor
Date Posted: 13 Jul 2016 at 8:26pm
Let me just say that when one does fly apart, it is not a pretty scene in the governor "room". I have seen ones that were so loose that I could not put them back in with any sense of confidence.
regards,
Ken McGregor
|
Posted By: Larry(OH)
Date Posted: 14 Jul 2016 at 8:56am
I always have wondered how long those things are good for. I have never seen any problems with one, BUT......
-------------
'40 WC puller, '65 770 Ollie
*ALLIS EXPRESS contact*
I can explain it to you, BUT I cannot understand it for you!!
|
|