Farm Equipment - WD PTO Noise

Print Page | Close Window

WD PTO Noise

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=12527
Printed Date: 31 Jan 2025 at 1:55pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: WD PTO Noise

Posted By: Dave H
Subject: WD PTO Noise
Date Posted: 16 May 2010 at 2:30pm

Hi all. I told my neighbor I would get some basic advise for him for his WD PTO ailement. I don't have a clue since I have a D 15 and the books for it.

He uses this WD (believe it or not) to power his 10 foot three blded mower for cutting grass on and round his air strip.

Anyow Tommy told me this am that the gear that drives the pto shaft has chipped teeth. He does have another WD parts tractor in a shed. So I am looking for some basic guidance to give him on how to get to the innerds to replace the bad gears.

Like do you split it and then what, or can you get it done from underneath. I am assuming that it is a tranny disassembly?

So would apreciate some basic guidance on how to go about it.

Thanks all

Replies:

Posted By: Don(MO)
Date Posted: 16 May 2010 at 2:58pm

If it was me, I'd Look at the rear PTO shaft bearing and then drain the oil and then drop the PTO box and look at the gears, bearings in there first, Then look at the drive gear in the trans.

Don

-------------
3 WD45's with power steering,G,D15 fork lift,D19, W-Speed Patrol, "A" Gleaner with a 330 corn head,"66" combine,roto-baler, and lots of Snap Coupler implements to make them work for their keep.

Posted By: CTuckerNWIL
Date Posted: 16 May 2010 at 3:41pm

There are gears in the bottom cover. If it is one of those, drain the fluid,remove the bottom cover and replace it with the one off the parts tractor. If it is higher up, the tranny would have to come apart.

-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF

Posted By: norm [ind]
Date Posted: 16 May 2010 at 6:55pm

can be done without splitting the tractor have replace many drop pto box an give a good inpection can see all from there all but top gear can see it if battery box is removed if parts tractor has lube in it it will be ok tafe off hyd. pump an do all your work thru the pump cavity can get upper gears out of there if upper gears are bad

for get gear count puter at home call 1-574-342-4545 for info.

Posted By: norm [ind]
Date Posted: 16 May 2010 at 6:59pm

we also have the gears in stock for repair if you are lucky maybe just top idler gear on pto box also check the pto pin as it is a good culprit for a gear failure

Posted By: KY
Date Posted: 17 May 2010 at 2:46pm

I have had two 45s ptos out. Both times it was the top idler gear. weakest point. You have to split the tractor and remove pump hand clutch ect. I have done it twice , not much fun. Bush hog and age got em.