Farm Equipment - 7010 powershift hyd filter light?

Print Page | Close Window

7010 powershift hyd filter light?

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=12318
Printed Date: 31 Jan 2025 at 6:09am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 7010 powershift hyd filter light?

Posted By: Clay Bragg
Subject: 7010 powershift hyd filter light?
Date Posted: 11 May 2010 at 8:23pm

light comes on when working in low range 5 6 gear switched to high range 1 gear no light.changed fluid and filter this spring.any ideas?

Replies:

Posted By: SHAMELESS
Date Posted: 12 May 2010 at 2:51am

what rpm does the light come on or go

off? light should be on under 1800 rpm

Posted By: Clay Bragg
Date Posted: 12 May 2010 at 7:45pm

light is on at 2300 rpm filter light should never be on should it?trans preassure light can be on at less than 1500 if im not mistaken

Posted By: michaelwis
Date Posted: 12 May 2010 at 7:55pm

our 7040 light used to come on at low rpm,s ..then it came on all the time .. thru it all the tractor worked fine ..if it was my tractor i would put a new filter on it each year ..keep an eye on oil level ..and not worry .. of course you could drain the system every 5 yrs or so as moisture could get to be an issue ...

-------------
WD WD45 DIESEL D 14 D-15 SERIES 2 190XT TERRA TIGER ac allcrop 60 GLEANER F 6060 7040.and attachments for all Proud to be an active farmer

Posted By: mnziggy
Date Posted: 12 May 2010 at 9:28pm

only trans pressure light should come on below 1800 rpm. Either new filter is bad or sensor could be defective. There a two magents is plastic valve that fits on top of filter, when filter is plugged, oil pressure forces filter down and moves magnets away from sensor in filter head. Check to make sure magnets and holder is in good shape.

Posted By: skipwelte
Date Posted: 13 May 2010 at 12:52pm

Could be the pickup on the outside of the filter isnt working, those used to be spendy. Seems there was always a little trouble gettin the lite to be off. I dont know if the sender was to sensaitive or the spring that holds the filter up in the canister is to weak. Good luck.