snap coupler/pin hitch blade pics
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=10934
Printed Date: 23 Jan 2025 at 2:57pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: snap coupler/pin hitch blade pics
Posted By: caRon
Subject: snap coupler/pin hitch blade pics
Date Posted: 11 Apr 2010 at 6:35pm
|
workes great. The coupler eye pinned up nice and tight into the drawbar clevis.
 
|
Replies:
Posted By: Leon B MO
Date Posted: 11 Apr 2010 at 6:45pm
|
Hey CARon, nice setup. I do have an extra pin hitch end that came off of a pin hitch plow. I don't know if the bolt holes are the same but they should be. That might be easier to line up than hour clevis.
Leon B MO ------------- Uncle always said "Fill the back of the shovel and the front will take care of itself". |
Posted By: caRon
Date Posted: 11 Apr 2010 at 6:59pm
| Leon, I just might be interested in that pin hitch end. I hooked the clevis to the eye first, and then mouted it to the tractor. Had to tap it on with a hammer, went onto the eye good and tight, but not enough to damage the clevis at all. |
Posted By: ChuckLuedtkeSEWI
Date Posted: 11 Apr 2010 at 7:49pm
| Wasn't the pin hitch hookup holes further forward then the snap coupler eye holes, because they had to make room up for the snap coupler bell being further back then the pin hitch hole. I know when I got my disk, it didn't have a snap coupler eye on it, and when I tried using the original hole for the pin hitch setup which was already taken off before I got it, it worked but the chains to lift the disk were too far back. Once I shortened up the hitch and put the snap coupler eye further back it worked fine. I think if I remember right you use the back pin hitch hole as the front snap coupler hole and then drill a new hole. |