B/C governor question what gives here?
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=10904
Printed Date: 23 Jan 2025 at 2:58pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: B/C governor question what gives here?
Posted By: Dave Everett
Subject: B/C governor question what gives here?
Date Posted: 11 Apr 2010 at 1:37am
|
just rebuild a B from different pieces, now throttle has only 2 positions, tickover, open one snotch then is flat out, im missing something here but i cant think what............ can I have some advice please...
thanks in advance.............
|
Replies:
Posted By: Dusty MI
Date Posted: 11 Apr 2010 at 7:02am
|
Sounds like the governor is not working. Dusty ------------- 917 H, '48 G, '65 D-10 series III "Allis Express" |
Posted By: Dick L
Date Posted: 11 Apr 2010 at 7:17am
|
Rather than type it over for the umpteenth time I will give you a link. Cross Over Arm Adjustment http://www.ytmag.com/cgi-bin/viewit.cgi?bd=ac&th=125547 - http://www.ytmag.com/cgi-bin/viewit.cgi?bd=ac&th=125547 |
Posted By: Bill Deppe/AC Salvag
Date Posted: 11 Apr 2010 at 8:37am
| Be sure the thrust bearing is correct on the shaft |
Posted By: norm [ind]
Date Posted: 11 Apr 2010 at 10:07am
| every thing is not adjusted to specs start over dave throtle wide open go to left side carb wide open is linkage close to hole behind the fan should slidein with everything wide open if not bend to fit my 2 cents |
Posted By: Dick L
Date Posted: 11 Apr 2010 at 4:23pm
|
Either way Norm. The only way it would not work wide open is if the link from the cross over arm was not a proper match. In that case you would have a high RPM high or low depending on the length of the link. I have bought tractors with home made link rods. I also bought one that had a piece welded to the cross over arm. In calling out setting in the idle position is showing that the governor at idle is not holding the the butterfly back against the butterfly stop screw.  |
Posted By: norm [ind]
Date Posted: 11 Apr 2010 at 6:44pm
| go to a stock set up try again |