d19
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=10619
Printed Date: 27 Sep 2024 at 6:30am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: d19
Posted By: adamd-19
Subject: d19
Date Posted: 05 Apr 2010 at 9:13am
|
i just purchased a d19 gas. The hand clutch leaks oil around the shaft where the lever attaches, any ideas? Thanks
|
Replies:
Posted By: niel ev
Date Posted: 05 Apr 2010 at 9:20am
|
There is aan oring on the shaft coming out of the torque tube probably is worn or dried out Niel
|
Posted By: adamd-19
Date Posted: 08 Apr 2010 at 10:18pm
|
Thanks, I'll tear into that next
|
Posted By: DSeries4
Date Posted: 08 Apr 2010 at 10:54pm
|
remember that shaft comes out the other size - there will be 2 o rings to replace.
|
Posted By: DSeries4
Date Posted: 08 Apr 2010 at 10:55pm
Posted By: gary ny
Date Posted: 09 Apr 2010 at 7:01am
|
Dseries4 Can those seals be changed without spliting the tractor.I am going to be painting a d17 for a guy that has the seal leaking and he thought that it would have to be split and I was not sure and I just have not had a chance to look into it yet But saw this post and thought I would ask someone how knows.
|
Posted By: skipwelte
Date Posted: 09 Apr 2010 at 9:40am
|
No you dont have to split tractor to put new orings on the power director lever cross shaft, as a matter of fact the shaft has to come out before you split the tractor. You may be able to remove the lever and snap ring and move the shaft out of the housing just enough to put on a new oring, then move it the other way and replace the oring on the other side. A D19 has the hi pro keys on the inside so the shaft will slide on the PD shift lever, early D17s have a set screw on the inside so youll have to remove it to slide the shaft far enough to change orings. Good Luck.
|
|