Loader not working properly.
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=104847
Printed Date: 30 Oct 2025 at 6:43pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Loader not working properly.
Posted By: 180shane
Subject: Loader not working properly.
Date Posted: 16 Apr 2015 at 6:15am
|
On my 180 when you pull the lever back to tilt the forks it doesn't move. It makes like a vibrating sound but won't move. The bush hog loader raises and lowers just fine but the tilt will not move. Thanks in advance.
|
Replies:
Posted By: MACK
Date Posted: 16 Apr 2015 at 6:30am
|
Couppler problems, not pluged all the way in, bad point, not a matched set or worn out set. MACK
|
Posted By: Rick
Date Posted: 16 Apr 2015 at 6:38am
|
Plenty hydraulic oil? Rick
|
Posted By: 180shane
Date Posted: 17 Apr 2015 at 8:56pm
|
Just checked, the fluids and they were good and the couplers were engaged fully. Still no luck.
|
Posted By: CTuckerNWIL
Date Posted: 17 Apr 2015 at 9:14pm
Do you have 2 remotes running the loader? One for lift and one for tilt?
-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF
|
Posted By: SHAMELESS
Date Posted: 17 Apr 2015 at 9:19pm
|
like Mack says...and maybe change the hyd ends...sounds like it's starving for fluid!
|
Posted By: kinghunter
Date Posted: 17 Apr 2015 at 9:57pm
|
i had this same problem and it ended up being the ends i couldnt believe it because i couldnt tell defference between new and old but i changed them and it works great.
|
Posted By: 180shane
Date Posted: 19 Apr 2015 at 7:56pm
|
Are you guys talking about changing the female ends on the tractor or the male ends on the hoses?
|
Posted By: tbran
Date Posted: 19 Apr 2015 at 8:11pm
yes
-------------
When told "it's not the money,it's the principle", remember, it's always the money..
|
Posted By: tbran
Date Posted: 19 Apr 2015 at 8:12pm
you could do some trouble shooting and switch controls for tilt and raise, see if problem follows hoses.
-------------
When told "it's not the money,it's the principle", remember, it's always the money..
|
Posted By: slip knot
Date Posted: 19 Apr 2015 at 9:57pm
|
Had the same problem with my 500 loader. found one of the quick connects would let oil flow one direction but not the other. This was a while back and my hairs just aout grown back out. A real pita.
|
Posted By: 180shane
Date Posted: 20 Apr 2015 at 9:02pm
|
Thanks everyone for the help. Ended up being the male end of the hose . Replaced and works wonderful now.
|
|