Farm Equipment - wd 45 torque tube shaft

Print Page | Close Window

wd 45 torque tube shaft

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=10343
Printed Date: 22 Jan 2025 at 12:17pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: wd 45 torque tube shaft

Posted By: bsb45chalm
Subject: wd 45 torque tube shaft
Date Posted: 30 Mar 2010 at 8:30pm

replaced rear bearing +seals using front bearing again seem fine when put together with snap rings on drive gear and in the housing with coupling flange in with snap ring on is it normal for 1/8" play in shaft?? thank you for the time and hopfully a reply Thanks always for the insight I read the book but no info>>

Replies:

Posted By: skipwelte
Date Posted: 31 Mar 2010 at 11:13am

1/8 inch is a lot. Id recheck and see if you can get end play down to less than a 1/16th.