Carb help!
Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Pulling Forum
Forum Description: Forum dedicated to Tractor and Garden Pulling
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=100669
Printed Date: 24 Nov 2024 at 11:01pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Carb help!
Posted By: mufflerboltz
Subject: Carb help!
Date Posted: 19 Jan 2015 at 4:46pm
|
Like a little help on what size/brand of carb i should run on my WC. i have 327 ci and running a custom header/intake because my club allows it and i do not want to cut and grind on the original cast intake. Also what is a decent size tube to run for the exhaust and intake? Thanks guys!
|
Replies:
Posted By: mufflerboltz
Date Posted: 21 Jan 2015 at 7:41am
|
well I found out that im going to you 1.5 inch intake tube but still looking for advice on what carburetor i should run. Would a Bendix off an an oliver 310 be to much?
|
Posted By: DrAllis
Date Posted: 21 Jan 2015 at 8:08am
|
I ran one of those big Bendix carbs (190XT) on a 390 inch engine and it worked just fine.
|
Posted By: mufflerboltz
Date Posted: 21 Jan 2015 at 4:22pm
|
Dr. Allis, do you know the size of the venturi in the 190 carb?
|
Posted By: DrAllis
Date Posted: 21 Jan 2015 at 7:30pm
|
I do not. I see in the 190XTG Service Manual it is a size #30 and the straight 190 is size #28. You'll be surprised how well it will work and the more RPM the better.
|
Posted By: mufflerboltz
Date Posted: 22 Jan 2015 at 7:48am
|
so would you recommend the bendix over the holley?
|
Posted By: DrAllis
Date Posted: 22 Jan 2015 at 11:06am
|
The best thing you can do with the Holley is leave it in the box of your pickup with the tailgate open and go for a long drive.
|
Posted By: mufflerboltz
Date Posted: 22 Jan 2015 at 12:30pm
Posted By: Steve in NJ
Date Posted: 22 Jan 2015 at 2:09pm
I'll second the Doc on that! As a matter of fact, use it as a wheel chock! Then back over it..... I believe I have a couple of those large bore Zenith/Bendix dudes on the shelf if interested. I can mildly message one for ya if interested... Call or drop me an e-mail.
Steve@B&B
-------------
39'RC, 43'WC, 48'B, 49'G, 50'WF, 65 Big 10, 67'B-110, 75'716H, 2-620's, & a Motorhead wife
|
Posted By: mufflerboltz
Date Posted: 01 Feb 2015 at 7:45am
|
Dr. Allis, awhile back you told me a place where a guy can by carb parts to customize a carb. I wrote it down and since I lost it I was wondering if you could tell me the website again. Thanks
|
Posted By: DrAllis
Date Posted: 01 Feb 2015 at 4:20pm
|
McDonald Carb & Ignition.....Jefferson, Georgia.....706-367-4179
|
Posted By: mufflerboltz
Date Posted: 02 Feb 2015 at 7:28am
|