This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


8050 Power Shift
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
scott in tenn View Drop Down
Bronze Level
Bronze Level


Joined: 27 Oct 2009
Location: selmer tennesse
Points: 65 		Post Options Post Options   Thanks (0) Thanks(0)   Quote scott in tenn Quote  Post ReplyReply Direct Link To This Post Topic: 8050 Power Shift
    Posted: 5 hours 37 minutes ago at 8:35pm
I have a 8050 power shift that the only thing it does is pull a New Holland round baler. 95 percent of the time I bale in 5th gear low range. My question is, is this hard on the transmission? Naturally tractor starts of in 4th then I shift to 5th and back down to 4th when bale starts tying. Having zero issues just looking for opinions from people who know more than me about the power shift. Thanks in advance for opinion. Scott
Back to Top
Sponsored Links


Back to Top
SteveM C/IL View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Location: Shelbyville IL
Points: 8605 		Post Options Post Options   Thanks (0) Thanks(0)   Quote SteveM C/IL Quote  Post ReplyReply Direct Link To This Post Posted: 4 hours 25 minutes ago at 9:47pm
Starting in 4 lo is a piece of cake. Can't see how it could be hard on anything. Im not an  expert as only 2yrs with an 8070 PS but I don't see an issue.
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 21799 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 3 hours 52 minutes ago at 10:20pm
Probably thee most important thing on a PST is making sure the trans brake "feel" stop is adjusted perfectly. You simply CANNOT have that inching pedal try to apply the trans brake one little bit when you stop to tie/dump a bale. You will surely destroy the C2/reverse clutch pack. Always roll to a stop or use the wheel brakes to stop, not the trans brake.
Back to Top
Ron(AB) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2009
Location: Alberta
Points: 962 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Ron(AB) Quote  Post ReplyReply Direct Link To This Post Posted: 2 hours 14 minutes ago at 11:58pm
What if you pulled the gear lever to neutral and used the wheel brakes to stop fast?
405, 7000, 7050, 8050, 8070, L3, 2300 & 2600 disk
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum