This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Model D engine swap

 Post Reply Post Reply
Author
Message
newbe2 View Drop Down
Bronze Level
Bronze Level


Joined: 16 Jan 2024
Location: California
Points: 35
Post Options Post Options   Thanks (0) Thanks(0)   Quote newbe2 Quote  Post ReplyReply Direct Link To This Post Topic: Model D engine swap
    Posted: 3 hours 5 minutes ago at 11:33am
History; 1953 model d with D15 diesel.
The on going story. I have obtained an early D17 engine that has been fitted to a 1949 WD tractor with the WD45 flywheel and clutch assembly, so it should be a direct fit for the model D grader. Problem, the crankshaft pulley is single belt and I need the 3 belt to operate the hydraulic pump. Jensales AC-P-D parts manual page 23 lists that part number as 097673, which does not come up in any search. Any one have one they are willing to part with? Or is the only option the 2 belt 70227395 which is available on line?

I have the D15 diesel that seems to be solid except for the broken crank at cylinder 4. The injector pump is rebuilt and has the new input shaft. The injectors were cleaned and serviced and the engine runs, sort of. Flywheel and clutch is 9 inch with 100 tooth ring gear. Anyone interested? willing to trade for the 3 belt pulley, shipping not included.
Back to Top
Sponsored Links


Back to Top
im4racin View Drop Down
Orange Level
Orange Level


Joined: 12 Jun 2017
Location: Garrison ND
Points: 940
Post Options Post Options   Thanks (0) Thanks(0)   Quote im4racin Quote  Post ReplyReply Direct Link To This Post Posted: 2 hours 23 minutes ago at 12:15pm
I got a tapered hub type of pulley for one I did the swap on. Worked good. Any industrial drive and bearing place should be able to help you out. Just need to crank nose diameter and belt width for them to find it
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.035 seconds.


Help Support the
Unofficial Allis Forum