Original Type B/C Seat

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   My Model C has a reproduction seat which consists of a piece of plywood and about four inches of foam padding covered with some cheap vinyl. It is better than nothing but I don't really like it. I do like the wide platform as it allows one to squirm around and also I enjoy giving the grandchildren rides, etc. so I do not wish to convert to any type of single bucket seat.

I am contemplating building a seat more like the originals which had springs inside and could be built to withstand a heavier operator (me) without bottoming out and jarring my backbone the way the foam padding on plywood does.

Does anyone have information as to how the originals were constructed? Did they use webbing underneath to support the springs, or did they just use a solid board? 

I am not concerned with building a show quality factory original type seat, just a good, sturdy, functional and comfortable seat.
I have been watching some utube videos of upholstering and I believe this is doable.

Thanks in advance 

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Les Kerf Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 08 May 2020 Location: Idaho Points: 786	Post Options Post Reply Quote Les Kerf Report Post Thanks(0) Quote Reply Topic: Original Type B/C Seat Posted: 2 hours 27 minutes ago at 1:26pm
	My Model C has a reproduction seat which consists of a piece of plywood and about four inches of foam padding covered with some cheap vinyl. It is better than nothing but I don't really like it. I do like the wide platform as it allows one to squirm around and also I enjoy giving the grandchildren rides, etc. so I do not wish to convert to any type of single bucket seat. I am contemplating building a seat more like the originals which had springs inside and could be built to withstand a heavier operator (me) without bottoming out and jarring my backbone the way the foam padding on plywood does. Does anyone have information as to how the originals were constructed? Did they use webbing underneath to support the springs, or did they just use a solid board? I am not concerned with building a show quality factory original type seat, just a good, sturdy, functional and comfortable seat. I have been watching some utube videos of upholstering and I believe this is doable. Thanks in advance

Sponsored Links