This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Garden Tractors
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Electric PTO Clutch Issue

 Post Reply Post Reply
Author
Message
GregLawlerMinn View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Lawler, Mn
Points: 1226
Post Options Post Options   Thanks (0) Thanks(0)   Quote GregLawlerMinn Quote  Post ReplyReply Direct Link To This Post Topic: Electric PTO Clutch Issue
    Posted: 13 Aug 2016 at 10:13am
OK what am I missing? The electric PTO clutch on my AGCO ALLIS 2020LC (Simplicity Legacy) lawn mower does not engage.
1. Replaced the switch and have power to the PTO Connector. A test light attached to the connector lights up when I activate the PTO switch.
2. Resized the air gap and checked Ohms on the clutch assy; talked to the service tech at Ogura (clutch Mfgr) and was advised that the clutch was defective since the Ohms was too high.
3 Bit the bullet and paid the $400 for a new clutch and I still have the same issue....the PTO clutch does not engage.

The spindles are free and can turn the blades by hand. So now I have a new switch and a new clutch and have not fixed the problem!

Edited by GregLawlerMinn - 13 Aug 2016 at 10:15am
What this country needs is more unemployed politicians-and lawyers.
Currently have: 1 D14 and a D15S2.
With new owners: 2Bs,9CAs,1WD,2 D12s,5D14s,3D15S2s, 2D17SIVs,D17D,1D19D;1 Unstyled WC
Back to Top
Sponsored Links


Back to Top
tadams(OH) View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 17 Sep 2009
Location: Jeromesville, O
Points: 9657
Post Options Post Options   Thanks (0) Thanks(0)   Quote tadams(OH) Quote  Post ReplyReply Direct Link To This Post Posted: 13 Aug 2016 at 2:45pm
Check your ground

Back to Top
jaybmiller View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Location: Greensville,Ont
Points: 21486
Post Options Post Options   Thanks (0) Thanks(0)   Quote jaybmiller Quote  Post ReplyReply Direct Link To This Post Posted: 13 Aug 2016 at 2:55pm
yup, bad or high resistance ground. I add a separate ground from EPTO mounting tab direct to battery, #14 wire is fine, only 4-5 amps being drawn.

Every E-PTO I've ever worked on and fixed  draws about 4 amps. So old school math.. 12 volts / 4 amps is 3 ohms. Easy to check if off tractor, connect one lug to battery, other to ammeter then battery. Just be sure DVM is set to 10 AMP scale  first . It'll make a nice, solid clunk 'pulling' in.

If the coil of the EPTO reads 'infinite' or 1999 , then it's open( no connection). either a break in the coil or more likely the connection to the connector. Both are repairable,depending on skill or wallet size !

Jay

3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor)

Never burn your bridges, unless you can walk on water
Back to Top
Coke-in-MN View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 12 Sep 2009
Location: Afton MN
Points: 41211
Post Options Post Options   Thanks (0) Thanks(0)   Quote Coke-in-MN Quote  Post ReplyReply Direct Link To This Post Posted: 13 Aug 2016 at 4:11pm
Most electrical is either a open , direct short or a grounding problem - and ground is most likely problem . A test lite and a ohm meter - two basic tools - the scratching the hot wire is real old school and not a good test .  
Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something.
"Challenges are what make life interesting; overcoming them is what makes life meaningful."
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.065 seconds.


Help Support the
Unofficial Allis Forum