WD Patrs

more pics.

Coultrain,

Man that fresh paint looks great! I love that part of the build! Reminds me of a kid putting model cars together! Your tank looks awesome!

Thanks for the pictures!

Not sure if that pulley will work to hand crank it. My guess is you dont plan to hand crank it much?:)

Regards,

Chris

D17 1958 (NFE), WD45 1954 (NFE), WD 1952 (NFE), WD 1950 (WFE), Allis F-40 forklift, Allis CA, Allis D14, Ford Jubilee, Many IH Cub Cadets, 32 Ford Dump, 65 Comet, 66 F100.

Coultrain63,

That fresh PO paint looks Awesome! Thanks for the update on your tractor!

Regards,

Chris!

D17 1958 (NFE), WD45 1954 (NFE), WD 1952 (NFE), WD 1950 (WFE), Allis F-40 forklift, Allis CA, Allis D14, Ford Jubilee, Many IH Cub Cadets, 32 Ford Dump, 65 Comet, 66 F100.

Jim Hancock wrote:

Curiosity question, Coultrain63...

What is the cooling fan off of or from?

No doubt about it, that'll sure move some air!

Good looking job to date, too!

The fan was on it when I got it. Interesting. I really never thought about it I just painted it. Thanks!

WOW... thats one sharp looking tractor !

I had to go back and look at all the PURDY pictures from 2 years ago ! Thanks for the update.

Edited by steve(ill) - 23 May 2021 at 6:04pm

Like them all, but love the "B"s.

This is from a response I gave about a WD45 decal question back in 2010. My tractor is a WD and these pics are from my WD.

The fill battery decal goes on the outside of the left side of battery box. About 1 inch or so from the top and centered front to back. The electrical diagram decal goes on the inside of the top battery box cover. Keep lever down goes on the little flat area on the quadrants left side by the hydraulic lever. Power Crater goes on the left side, lower rear of the engine block (going from memory on the power crater as my WD doesn't have that one). The Snap Coupler goes on the left side of the Snap Coupler bell under the tractor situated on the top half and somewhat centered. The tire one (there should be 2) go on each left wheel anywhere on the smooth face of the rim and somewhat centered. The grease joint goes on the steering shaft itself with the decal starting about even with the top of side frame and going up from there running lengthways on the shaft. And the shutters one goes about 1 inch below the hole for the shutter control handle on the front right side of the grill shell and centered with the hole. If your 45 didn't come with a distillate engine then you won't have this hole I believe. Hope I made sense. Here are pictures

This is the battery fill

This shows the inside of the battery lid w/ electrical diagram

This is where I believe the power crater goes

I forgot to get a picture of the snap couple but I think my description show work

Front left wheel

I couldn't get a good shot of the rear left but this is where it goes if this were the left wheel

Here are some others

This is supposed to be centered on the box but in an original film I spotted one that was off center so I put it off center to copy the one on the film

this is the patent numbers on the right hand side under fuel tank

Edited by Lonn - 23 May 2021 at 8:19pm

-- --- .... .- -- -- .- -.. / .-- .- ... / .- / -- ..- .-. -.. . .-. .. -. --. / -.-. .... .. .-.. -.. / .-. .- .--. .. ... -
Wink
I am a Russian Bot

nice looking tractor

That Tractor needs a nice new B&B wiring system on it! LOL! Great lookin' Tractor! Nice job!

Steve@B&B

39'RC, 43'WC, 48'B, 49'G, 50'WF, 65 Big 10, 67'B-110, 75'716H, 2-620's, & a Motorhead wife

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History