This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Allis Pins ID
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Dave (NE) View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Eagle Nebraska
Points: 2164 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dave (NE) Quote  Post ReplyReply Direct Link To This Post Topic: Allis Pins ID
    Posted: 09 Dec 2017 at 3:26pm
What do these pins fit or go to?  Found one cleaning Dad's stuff up, acquired the other at an auction last summer.  They look kind of like they would be for a three-point top link mounting to an implement.
 
 
 
Back to Top
Sponsored Links


Back to Top
Ken McGregor View Drop Down
Bronze Level
Bronze Level


Joined: 11 Sep 2009
Location: Strathroy, Ont
Points: 142 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Ken McGregor Quote  Post ReplyReply Direct Link To This Post Posted: 09 Dec 2017 at 4:31pm
I'm thinking they were used for the "pin" hitches on the rear of the WD and CA before the Snap Coupler hitch appeared. We used to have  a 2x14 plow on our WD that had  a pin hitch and there were pins like those to hold the coupler on the arms of the hydraulic hitch.

regards,
Ken McGregor
Back to Top
Dave (NE) View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Eagle Nebraska
Points: 2164 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dave (NE) Quote  Post ReplyReply Direct Link To This Post Posted: 09 Dec 2017 at 5:09pm
Ken, I know what you are talking about to connect the cultivator lift part to the tractor lift arms.  Those pins are smaller in diameter and shorter than what these are.  Dave
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.133 seconds.


Help Support the
Unofficial Allis Forum