![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
6x6 |
Post Reply ![]() |
Author | |
shameless dude ![]() Orange Level ![]() ![]() Joined: 10 Apr 2017 Location: east NE Points: 13607 |
![]() ![]() ![]() ![]() ![]() Posted: 07 Jan 2023 at 12:54am |
well...the 6x6 ATV i bought for the old lady.....ooooooops....I mean the loving wife, is sitting, won't run, has a Kohler V-twin OHC engine. runs on carb cleaner and starting fluid, flushed the fuel system and lines, new gas with a little bit of HEET in it, took the fuel pump hoses off (vacuum pump) and wasn't getting much out of it, order and replaced the fuel pump, still no change. sprayed lots of carb cleaner inside and outside the carb. am affraid to take the carb off, last time I messed with a little carb, a little spring zinged out and was never found...guess it was an important one! any ideas?
|
|
![]() |
|
Sponsored Links | |
![]() |
|
DiyDave ![]() Orange Level Access ![]() ![]() Joined: 11 Sep 2009 Location: Gambrills, MD Points: 54060 |
![]() ![]() ![]() ![]() ![]() |
if you can find the ID tag on the motor, it would help tremendously!
![]() |
|
Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need!
|
|
![]() |
|
Dave H ![]() Orange Level ![]() ![]() Joined: 11 Sep 2009 Location: Central IL Points: 3583 |
![]() ![]() ![]() ![]() ![]() |
how about the fuel filter? |
|
![]() |
|
Kansas99 ![]() Orange Level Access ![]() Joined: 26 Feb 2015 Location: W Kansas Points: 4867 |
![]() ![]() ![]() ![]() ![]() |
If there is a fuel shutoff the needle and seat are stuck shut. Had it happen on my generator and it didn't take long, it had sat for a little over a year without running. If memory serves me right it's on the side of the carb. Edited by Kansas99 - 07 Jan 2023 at 6:25am |
|
"Thank you for your service Joe & the Ho"-----Joseph Stalin
|
|
![]() |
|
fixer1958 ![]() Orange Level ![]() ![]() Joined: 13 Feb 2010 Location: kansas Points: 2434 |
![]() ![]() ![]() ![]() ![]() |
Fuel lines rotten in the tank maybe and sucking air.
Ethanol is good for that.
|
|
![]() |
|
JW in MO ![]() Orange Level ![]() ![]() Joined: 16 Feb 2010 Location: South KC Area Points: 2666 |
![]() ![]() ![]() ![]() ![]() |
My 720, the dip tube in the tank has a hole or crack in it, I have to make sure fuel is above it. I replaced a perfectly good fuel pump also. I just ran a hose from the pump inlet to a can of gas to prove my problem.
|
|
Maximum use of available resources!
|
|
![]() |
|
fjdrill ![]() Silver Level Access ![]() Joined: 13 May 2012 Location: Alabama Points: 366 |
![]() ![]() ![]() ![]() ![]() |
I'm with K99. electric fuel S/O, lower carb, flywheel side. They are kinda pricy.
|
|
![]() |
|
jaybmiller ![]() Orange Level Access ![]() Joined: 12 Sep 2009 Location: Greensville,Ont Points: 24656 |
![]() ![]() ![]() ![]() ![]() |
me too.... the 'frugal fix' is to unscrew the 'anti dieselling valve'(B&S term), rip off the rubber, then replace. Now get get flow 24/7 BUT the needle valve IS the shutoff. I've done 2, cut the gas line installed a B&S shutoff It might just need cleaning. easy to test, clean then hit with 12v and be 100% sure it MOVES...
|
|
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor) Never burn your bridges, unless you can walk on water |
|
![]() |
|
Dave H ![]() Orange Level ![]() ![]() Joined: 11 Sep 2009 Location: Central IL Points: 3583 |
![]() ![]() ![]() ![]() ![]() |
good idea, this will instantly tell if you have a fuel restriction. Clue to the shut off thingy, it has a wire or wires hooked to it. Have a new one on order for nine.
|
|
![]() |
|
DMiller ![]() Orange Level Access ![]() Joined: 14 Sep 2009 Location: Hermann, Mo Points: 33880 |
![]() ![]() ![]() ![]() ![]() |
My Thermalarc welder was that way, had to braze the pickup tube at rust thru line and change all 'rubber' fuel lines. V-twin Honda on it.
|
|
![]() |
|
shameless dude ![]() Orange Level ![]() ![]() Joined: 10 Apr 2017 Location: east NE Points: 13607 |
![]() ![]() ![]() ![]() ![]() |
fuel filter replaced, the gas tank is a gravity flow out the bottom, the hoses are clear (open), replaced a few hoses, will check the needle thingy when I go back out there.
|
|
![]() |
|
JohnColo ![]() Orange Level ![]() ![]() Joined: 03 Apr 2020 Location: Niwot, CO Points: 1263 |
![]() ![]() ![]() ![]() ![]() |
Sounds like it will be a fun toy once you get it running. Now be honest, did you REALLY buy it for the old lady, er loving wife or for yourself?
|
|
![]() |
|
shameless dude ![]() Orange Level ![]() ![]() Joined: 10 Apr 2017 Location: east NE Points: 13607 |
![]() ![]() ![]() ![]() ![]() |
gotta be for her John....I don't fit in it!! (to chubby)
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |