![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
6080 help, Dr, mack, tbran... |
Post Reply ![]() |
Author | |
Dkienzle ![]() Bronze Level ![]() Joined: 22 Feb 2013 Location: Central IA Points: 192 |
![]() ![]() ![]() ![]() ![]() Posted: 01 Nov 2018 at 12:29pm |
Have 6080 fwa that has developed a 100series problem. It's jumping out of gear. Specifically the range trans likes to pop out of intermediate, the problem is magnified ×10 when the fwa assist is engaged. It is a loader tractor, so it's seen a lot of clutching. 4spd trans acts fine and stays in gear. Checked trans oil at fill plug, full. Any ideas? Open to suggestions. Also acts like range trans is binding up, when it pops out of gear it WILL NOT Go back into range unless tractor is rolled forwards or backwards with the loader.
Edited by Dkienzle - 01 Nov 2018 at 12:31pm |
|
![]() |
|
Sponsored Links | |
![]() |
|
Stan R ![]() Orange Level Access ![]() Joined: 03 Dec 2009 Location: MA Points: 992 |
![]() ![]() ![]() ![]() ![]() |
Correct front/ rear tire sizes- i.e. wrong size tires will change the drive ratio, thus causes tire slippage and drive train takes a beating, especially on roads and hard packed soils?
|
|
![]() |
|
tbran ![]() Orange Level ![]() Joined: 14 Sep 2009 Location: Paris Tn Points: 3518 |
![]() ![]() ![]() ![]() ![]() |
Hmmm thoght I posted this , may have dozed off. The issue we have found is popping up more and more - it is the planetary gear set and needle brgs in the range - very common for new owners to not check the TRANSMISSION oil whjich is separate from the hydraulic oil which should be always run about a gallon over full.
|
|
When told "it's not the money,it's the principle", remember, it's always the money..
|
|
![]() |
|
Dkienzle ![]() Bronze Level ![]() Joined: 22 Feb 2013 Location: Central IA Points: 192 |
![]() ![]() ![]() ![]() ![]() |
Tbran, by oil level I'm referring to the oil fill plug in the right hand side of trans. It's full. Hydraulic in rear is also full. I betting your on the right path, you have pry seen plenty of this, what is the parts and cost associated with fixing this. Parts availability concerns me. Thanks guys
|
|
![]() |
|
GreenOrange ![]() Orange Level ![]() ![]() Joined: 11 Sep 2009 Location: Wisconsin Points: 849 |
![]() ![]() ![]() ![]() ![]() |
tbran - which one should be run a gallon over full in the 6000 series? Transmission or Hydraulic?
|
|
![]() |
|
tbran ![]() Orange Level ![]() Joined: 14 Sep 2009 Location: Paris Tn Points: 3518 |
![]() ![]() ![]() ![]() ![]() |
REAR END - Hydraulics - this is prevention of running low and seizing pinion gears to the shaft and destroying differential.
|
|
When told "it's not the money,it's the principle", remember, it's always the money..
|
|
![]() |
|
GreenOrange ![]() Orange Level ![]() ![]() Joined: 11 Sep 2009 Location: Wisconsin Points: 849 |
![]() ![]() ![]() ![]() ![]() |
Thanks for the tip!
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |