This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


C Bent push rod again
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Larry in Ill View Drop Down
Bronze Level
Bronze Level


Joined: 23 Feb 2012
Location: Central ILL
Points: 129 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Larry in Ill Quote  Post ReplyReply Direct Link To This Post Topic: C Bent push rod again
    Posted: 05 May 2012 at 6:11am
Good morning all,
I have a question about a bent push rod.  The engine was restored a few years ago and after about 50 hours of light use, I notice a ticking and occational pop out of the exhaust.  I had a bent push rod and valve.  I replaced the valve, guide, and rod and now again I have a bent rod.  The valve is fine with no unusual wear.  What would be the possible problems?


Edited by Larry in Ill - 05 May 2012 at 6:32am
Back to Top
Sponsored Links


Back to Top
B26240 View Drop Down
Orange Level
Orange Level


Joined: 21 Nov 2009
Location: mn
Points: 3865 		Post Options Post Options   Thanks (0) Thanks(0)   Quote B26240 Quote  Post ReplyReply Direct Link To This Post Posted: 05 May 2012 at 7:07am
Are you sure your replacement pushrod was straight? Any slight bend could get worse quickly, also excesive clearance  (rocker arm adjustment) posibly could cause it .
Back to Top
MBWisc View Drop Down
Silver Level
Silver Level


Joined: 13 Apr 2011
Points: 103 		Post Options Post Options   Thanks (0) Thanks(0)   Quote MBWisc Quote  Post ReplyReply Direct Link To This Post Posted: 05 May 2012 at 7:38am
Or a badly worn rocker arm assembly? Two years after overhaul my B turned into a three cylinder. A push rod had come up along side the rocker. Rocker assembly was worn out. Replaced the assembly and all is well.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.070 seconds.


Help Support the
Unofficial Allis Forum