WD45 Spinout nut size.

 My WD45 is about an hour away. What size socket fits the spinout bolts so I can take the correct tools? I noticed that the left side is out further than the right and I want to even them out.

Thanks for the info. I have only owned the tractor a couple of months and dont know when they were moved last. I will take some good penetrating oil just in case.

Good luck!!!!

Thanks to all for advice, had no problems adjusting the wheel. I had an old tire iron that fit better than the socket, stops were no problem either.Just had to scrape away old paint.  Pretty cool idea they had, was this the first of the adjustable wheels?

IF I recall  yes 3/4 ",  half inch breaker bar and a hammer, pipe,  Pen.oil, Never Seize .  I think 19 mm Socket is the next size down. All six point.  Use the hammer and pipe to shock them loose, once loose move them until smooth.   To tighten  turn some or all 1/2-3/4 way tight and after all set at that point try to tighten the rest of the way. Any that have the weight of tractor on them can be very hard to turn , you may need to re loosen them all and start over.   I use the hammer to tap on the old breaker bar while pushing on a 24" pipe  to loosen and tighten. You may find that you need to move the tractor some to get them tight, and locks on the one rail to keep them set. I HOPE YOU GET AN EASY ONE!!!  Most I do have been setting for years and drive me nuts the first time.  Be Safe!!