Could someone post a pin of they're hydraulic control linkage down by the pump? I hooked it back up how I remember it, and now I can't raise the lever even half way.It's as if something is in the way? Usually if I play with something long enough and look at it hard enough, I'll figure it out. Girlfriend's the same way. I played with if for the first half of the dar yesterday, then after I gave up and started working on the front end she started playin around with it and couldn't figure it out either. She got her dad's parts book, and it shows the thicker rod comming off the lever, but not where it goes on the pump. It goes in the second hole back from the front of the pupm and the skinny one goes to the first hole correct? r the other way around? Thanks.
Topic Options
Post Options
Thanks(0)
Hope this is enough to help you
