Have a 615 hoe yet off my HD4, on the bracket , it was also used as a tool carrier and used to attach weights to back. Hook on lower side that hoe dropped into and on the top two pin boss drilled through plate for top of hoe. 2 sides were attached to each other with X brace between. Long rod went from bracket to loader frame and this had a threaded end so bracket could be tensioned to loader frame.
Seat bracket is just a flat iron with a hinge on end that attached to hoe. flip up to run machine, flip down to use hoe as seat ends up over opperator station of machine.
On my hoe I replaced the lower 2 pins with a solid rod running across the hoe instead of 2 pins. Just dropped hoe onto lower hook area of carrier, then used hoe to position itself to fit top pins.
Edited by Coke-in-MN - 16 Jan 2010 at 5:31am
Topic Options
Post Options
Thanks(0)
