This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


8050 help
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Mark_SE/CO View Drop Down
Bronze Level
Bronze Level


Joined: 13 Jul 2010
Points: 10 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mark_SE/CO Quote  Post ReplyReply Direct Link To This Post Topic: 8050 help
    Posted: 27 Dec 2010 at 11:33am
      I have an 1982 8050 which has devoloped an oil leak out of the exhaust manifold between cylinders 4 and 5 it is clean oil so i suspect a seal going out of the turbo. Any experience with the problem would be greatly appreciated.  There is no squeal from the turbo so i dont thing bearings are going out yet but it seems to me there needs some attention.  Any expertise is welcome.
Back to Top
Sponsored Links


Back to Top
redline View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Collins, IA
Points: 1013 		Post Options Post Options   Thanks (0) Thanks(0)   Quote redline Quote  Post ReplyReply Direct Link To This Post Posted: 27 Dec 2010 at 12:10pm
If you suspect the turbo, get it checked out or rebuilt. The engine can and will run on the oil that leaks by on the "pressure" or clean air side of the turbo. You then have no throttle control or means of turning the engine off. You can put it in gear and stall it, but otherwise it will run wild and can be very harmful.
Back to Top
Lynn Marshall View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 13 Sep 2009
Location: Dana, Iowa
Points: 2318 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Lynn Marshall Quote  Post ReplyReply Direct Link To This Post Posted: 27 Dec 2010 at 1:17pm
I would sooner think that what you see is unburnt diesel fuel mixed with the exhaust soot to look like oil. Probably an injector not firing quite right.Usually see this on cold engine startup,but a lot of times the leak dries up after the engine warms up.
Back to Top
Mark_SE/CO View Drop Down
Bronze Level
Bronze Level


Joined: 13 Jul 2010
Points: 10 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mark_SE/CO Quote  Post ReplyReply Direct Link To This Post Posted: 31 Dec 2010 at 8:15am
Thanks for the help. Pulled the injectors out and had them tested. Tech said they were just "puked" fuel out with no patteren. The turbo looked like fuel was going through the blades so it was sent off also but havent heard anything back as of yet. Thanks again
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum