manifold and studs

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Working on our RC.

bought new "American made" manifold and a set of studs.

Should the studs be threaded all the way in?  They don't seem to tighten until all the way.  And all the way in, I'm doubtful I can thread a nut as they seem short.

Also, outside manifold holes for the short studs are 1/2 hole off-have any of you run into this situation?  If so, what did you do?

Old manifold lines up fine.

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
WC7610 Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 11 Sep 2009 Location: Sioux City, IA Points: 764	Post Options Post Reply Quote WC7610 Report Post Thanks(0) Quote Reply Topic: manifold and studs Posted: 28 Dec 2010 at 10:45am
	Working on our RC. bought new "American made" manifold and a set of studs. Should the studs be threaded all the way in? They don't seem to tighten until all the way. And all the way in, I'm doubtful I can thread a nut as they seem short. Also, outside manifold holes for the short studs are 1/2 hole off-have any of you run into this situation? If so, what did you do? Old manifold lines up fine.
	Thanks Most Bad Government has grown out of Too Much Government- Thomas Jefferson

Sponsored Links