This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Torsion bar bracket on 200
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Fritz View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 19 Feb 2024
Location: Wellington ohio
Points: 19 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Fritz Quote  Post ReplyReply Direct Link To This Post Topic: Torsion bar bracket on 200
    Posted: 12 Jun 2024 at 5:08pm
Managed to get the thing off to make repairs, but how to get proper torque on the corner nuts behind the torsion bar?
Thanks, Fritz
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20677 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 12 Jun 2024 at 6:38pm
Don't know why you would need to remove it unless you were working on the torsion bar. Don't think there is a "torque" for those two lock nuts. I would normally say loosen each nut 2 full turns and remove the four bolts that hold the brackets and then disassemble. When assembling, tighten the two nuts 2 full turns tight and it is where it was before.
Back to Top
Fritz View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 19 Feb 2024
Location: Wellington ohio
Points: 19 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Fritz Quote  Post ReplyReply Direct Link To This Post Posted: 12 Jun 2024 at 7:17pm
Okay thank you I will remember that. The reason I took it off was I wanted a flat surface to bolt my splitting stand to, I have to strip the housing bare and I have to be able to wheel it around in my cramped shop if other emergencies arise. (Can’t block the lift).
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.045 seconds.


Help Support the
Unofficial Allis Forum