This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


HD-11EP
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Hard wood View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 14 Nov 2021
Location: Tennessee
Points: 5 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hard wood Quote  Post ReplyReply Direct Link To This Post Topic: HD-11EP
    Posted: 14 Nov 2021 at 8:35pm
Hi New to this site just bought a HD-11EP serial number 13720 re sealed the roosa Master DB injection pump DBGFC 637 41AF timed it 20° Before TDC ? Engine hard to get started once running sounds pretty good but after 30 minutes of grading in this Tennessee Red Clay it heats up from 190 to 210 and losses power if I let it idle approximate 5 minutes it drops back to around 190 and runs full throttle again radiator is Clea Best I can and looks good fan belts tight I'm wondering if my timing is off any help would be greatly appreciated thanks
Back to Top
Sponsored Links


Back to Top
DMiller View Drop Down
Orange Level Access
Orange Level Access


Joined: 14 Sep 2009
Location: Hermann, Mo
Points: 31151 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DMiller Quote  Post ReplyReply Direct Link To This Post Posted: 15 Nov 2021 at 5:01am
Should have been a timing pointer and line on the engine front crankshaft damper and timing cover, the pump side window has a timing mark, if was not on point in both conditions at the same time you were not In Time.  If continue to run it off time will burn it down.
Back to Top
Hard wood View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 14 Nov 2021
Location: Tennessee
Points: 5 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hard wood Quote  Post ReplyReply Direct Link To This Post Posted: 15 Nov 2021 at 10:00pm
Yes there's one in the Bell housing I set it on 20 ° before TDC and mark inside the pump just under the lid with the 2 little screw
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum