This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Allis Chalmers Track Loader GD 6 G
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Hill Top Ranch View Drop Down
Bronze Level
Bronze Level


Joined: 29 Aug 2022
Location: Adkins, Texas
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hill Top Ranch Quote  Post ReplyReply Direct Link To This Post Topic: Allis Chalmers Track Loader GD 6 G
    Posted: 29 Aug 2022 at 3:57pm
I have a Allis Chalmers  HD 6 G late model track loader.  I need information on how to install the pin that holds the brake operating pin to the bell crank.
Back to Top
Sponsored Links


Back to Top
gemdozer View Drop Down
Orange Level
Orange Level


Joined: 17 Sep 2009
Points: 989 		Post Options Post Options   Thanks (0) Thanks(0)   Quote gemdozer Quote  Post ReplyReply Direct Link To This Post Posted: 29 Aug 2022 at 7:25pm
You should have a plug on side housing rear the sprocket
Back to Top
Hill Top Ranch View Drop Down
Bronze Level
Bronze Level


Joined: 29 Aug 2022
Location: Adkins, Texas
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hill Top Ranch Quote  Post ReplyReply Direct Link To This Post Posted: 30 Aug 2022 at 9:14am
The pin goes in front of the sprocket and not the rear.
Back to Top
gemdozer View Drop Down
Orange Level
Orange Level


Joined: 17 Sep 2009
Points: 989 		Post Options Post Options   Thanks (0) Thanks(0)   Quote gemdozer Quote  Post ReplyReply Direct Link To This Post Posted: 30 Aug 2022 at 10:21am
Yes the pine go in front sprocket hole and that pine have a center hole and you can use a fine screw driver in the hole for pushing the pine in bellcrank
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.031 seconds.


Help Support the
Unofficial Allis Forum