| Author |
 Topic Search  Topic Options
|
nickia 
Orange Level
Joined: 11 Sep 2009
Location: alden iowa
Points: 785
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: 712 allis lawn tractor pto
Posted: 07 May 2021 at 8:53pm |
|
Can some one tell me the proper way to adjust the pto on my 712? If I tighten it to tight it wont disengage and try's to turn when I start it, if I loosen the nut she just slips any ideas?
|
 |
|
Sponsored Links
|
|
|
AC720Man
Orange Level
Joined: 10 Oct 2016
Location: Shenandoah, Va
Points: 4926
|
Post Options
Thanks(0)
Quote Reply
Posted: 07 May 2021 at 10:15pm |
|
Not familiar with the 712, assuming manual actuation? If so, the total “throw” of the lever should go from loose belt, no engagement, to 3/4 movement full engagement with spring compression the rest of the pull to lock. The spring allows deflection of the belt to keep it tight without slippage. Make sure you have full throw with no binding, you may have the wrong length belt?
|
|
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD
|
|
nickia
Orange Level
Joined: 11 Sep 2009
Location: alden iowa
Points: 785
|
Post Options
Thanks(0)
Quote Reply
Posted: 07 May 2021 at 10:20pm |
ok thanks i'll look into the belt length
|
|
Mikez
Orange Level Access
Joined: 16 Jan 2013
Location: Usa
Points: 8391
|
Post Options
Thanks(0)
Quote Reply
Posted: 07 May 2021 at 10:50pm |
|
nickia are you referring to like the lever on side of frame to engage mower. Which nut are you tightening
|
|
nickia
Orange Level
Joined: 11 Sep 2009
Location: alden iowa
Points: 785
|
Post Options
Thanks(0)
Quote Reply
Posted: 08 May 2021 at 5:35am |
the large nut that holds the cone clutch togeather
|
|
Mikez
Orange Level Access
Joined: 16 Jan 2013
Location: Usa
Points: 8391
|
Post Options
Thanks(0)
Quote Reply
Posted: 08 May 2021 at 10:22pm |
oh have you had that apart. That nut should be able to be tightened right up, the inner clutch part does the moving when you in gage the lever. Maybe the lock ring is messed up allowing the shaft to move.
This is from service manual if you’d like me to send you a copy of how to take apart.
Edited by Mikez - 08 May 2021 at 10:41pm
|
|
