This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Ca zenith venturi
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
ACCA52 View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 26 Jul 2021
Location: Grove City PA
Points: 14 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ACCA52 Quote  Post ReplyReply Direct Link To This Post Topic: Ca zenith venturi
    Posted: 10 Jun 2022 at 7:28pm
I have two ca zenith carbs with different venturis. One is a 13 then other is a 16. Is one better than the other. Tractor seemed to run very ritch with the 16 in, have not tried the 13 yet, as just rebuilt carb.
Back to Top
Sponsored Links


Back to Top
ACCA52 View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 26 Jul 2021
Location: Grove City PA
Points: 14 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ACCA52 Quote  Post ReplyReply Direct Link To This Post Posted: 10 Jun 2022 at 9:06pm
I found a site that lists the 13 as the stock venturi, so going to put it in and give it a try

Edited by ACCA52 - 10 Jun 2022 at 10:31pm
Back to Top
steve(ill) View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: illinois
Points: 81302 		Post Options Post Options   Thanks (0) Thanks(0)   Quote steve(ill) Quote  Post ReplyReply Direct Link To This Post Posted: 10 Jun 2022 at 10:09pm
I think the number is the BORE of the venturi in millimeters... 13 mm would be just over 1/2 inch ( .511) ...... the CA is a 125 cubic inch motor... If you had the same carburetor on a 150 cubic inch motor ( example)... then it might use the 16 mm venturi
Like them all, but love the "B"s.
Back to Top
PaulB View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Rocky Ridge Md
Points: 4753 		Post Options Post Options   Thanks (0) Thanks(0)   Quote PaulB Quote  Post ReplyReply Direct Link To This Post Posted: 11 Jun 2022 at 6:05am
Which one I'd use would depend on what your use would be. Farm use I'd go with the 13. If all that you do is pulling and you've run out of power, then go with the 16 and get the A/F mixture correct. If the 13 give you the power that you need for your selected gear and tire size then stick with it. In pulling you can overpower your gear and tire size and do worse than having just a little less power.
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum