This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Making splitting stands for a 190
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Mrgoodwrench View Drop Down
Orange Level
Orange Level
Avatar

Joined: 03 Apr 2011
Location: CHICORA PA
Points: 2087 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mrgoodwrench Quote  Post ReplyReply Direct Link To This Post Topic: Making splitting stands for a 190
    Posted: 03 Oct 2024 at 2:01pm
I need to build a set of splitting stands for a 190xt. I gave one that holds the rear using the 4 large bolt holes under the trans. Now I want to build a set for the front to bolt to the frame rails near the bell. I’m sure someone here has done this. I’m looking for ideas and how heavily they need built. I want to have it on casters. I gave a set that are rated for 1200lbs each so I think those should work.
There are 3 ways to do job GOOD, FAST, CHEAP. YOU MAY CHOOSE 2. If its FAST & CHEAP it won't be GOOD, if it's GOOD & CHEAP it won't be FAST, and if its GOOD & FAST it won't be CHEAP!!!!
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20522 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 03 Oct 2024 at 3:56pm
I've used 3 inch channel iron on mine with 3/8" thick center for the vertical position. You'll need something to go forward at an angle to keep the channel iron vertical. Connect both channels somehow across under the engine. Make sure to use one long 3/4" dowel on each side frame to hold the engine up.
Back to Top
RedHeeler79 View Drop Down
Bronze Level
Bronze Level


Joined: 09 Sep 2023
Location: NE Kansas
Points: 115 		Post Options Post Options   Thanks (0) Thanks(0)   Quote RedHeeler79 Quote  Post ReplyReply Direct Link To This Post Posted: 03 Oct 2024 at 4:09pm
I used 4” channel uprights and lower crossmember, with scaffold jacks for height adjustment. Bolted my casters to the bottom of scaffold jack feet. Worked great on my D17 clutch job. I found that using more than one bolt hole in the frame rail on each side negated the need for diagonal supports, but you will probably want them on a heavier machine..[]

Edited by RedHeeler79 - 03 Oct 2024 at 4:10pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum