8070 water cooled manifold.

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Looked through service manual (AC) 3 times for "best practices" on install of the manifold. Can't find a word about it. Getting it ready to mount and laid straight edge across intake side to thermostat  hsg water port and off way too much in my opinoin. When finished they both are attatched to the same plane on the head. It turns into a job getting bolts out and  T-stat hsg  separated ,gasket scraped clean etc. Last one 14yrs ago I don't remember but I think I put the cooler in place then attatched the T-stat hsg. Kinda sucky because you have to tighten against head and draw up to manifold at same time. "Proceedure" is what I was looking for but can not find. Opinions? 
Maybe your supposed to lay on a flat surface and assemble first?

Edited by SteveM C/IL - 22 Oct 2023 at 11:21pm

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
SteveM C/IL Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Location: Shelbyville IL Points: 8239	Post Options Post Reply Quote SteveM C/IL Report Post Thanks(0) Quote Reply Topic: 8070 water cooled manifold. Posted: 22 Oct 2023 at 11:18pm
	Looked through service manual (AC) 3 times for "best practices" on install of the manifold. Can't find a word about it. Getting it ready to mount and laid straight edge across intake side to thermostat hsg water port and off way too much in my opinoin. When finished they both are attatched to the same plane on the head. It turns into a job getting bolts out and T-stat hsg separated ,gasket scraped clean etc. Last one 14yrs ago I don't remember but I think I put the cooler in place then attatched the T-stat hsg. Kinda sucky because you have to tighten against head and draw up to manifold at same time. "Proceedure" is what I was looking for but can not find. Opinions? Maybe your supposed to lay on a flat surface and assemble first? Edited by SteveM C/IL - 22 Oct 2023 at 11:21pm

Sponsored Links

DrAllis Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Points: 20485	Post Options Post Reply Quote DrAllis Report Post Thanks(0) Quote Reply Posted: 22 Oct 2023 at 11:57pm
	However you choose to do it. The assembly has to be flat or bad things can happen. The manifold gasket needs to be glued solidly on one side for sure to help keep it from blowing out, usually above the starter area. I usually RTV the other side to seal. Re-check manifold bolt torque cold after a few hrs of run time.